Arcan 3-Ton Aluminum Review: Floor Jacks Buying Guide

By Roger Holden. Researched product comparison.

A floor jack lifts a corner of the car so you can fit jack stands and get wheels off the ground. A good one lifts quickly, rolls smoothly and lowers under control. The ARCAN 3-Ton Aluminum Low Profile Floor Jack is a light aluminum with dual pump option that I would short-list for most home mechanics. Using the flimsy scissor jack from the trunk for garage work, or wanting tire rotations and brake jobs to take minutes instead of an hour, are the usual reasons to upgrade. Before you buy, it helps to know what this listing does well, where it falls short and whether it matches your vehicle and the jobs you plan to do.

Key product details

Who I would recommend it to

This pick makes the most sense for most home mechanics. The listing highlights 3 ton capacity, aluminum frame, low profile, dual piston quick lift and padded handle. Owners tend to point to light to move, lifts fast and fits under lowered cars as the main reasons to choose it. If that matches the jobs you tackle in your own garage, it belongs on your list.

Choosing the right one

Choosing the wrong size or rating is where most floor jack purchases go wrong. A 3-ton jack covers most cars, crossovers and light trucks; check the rating against your vehicle’s weight per corner. Check the minimum saddle height against your car’s jacking points, especially on lowered or sporty cars. Buying for the vehicle and jobs you really have, not the biggest number on the box, is what keeps a tool from gathering dust.

Setup, safe use and everyday care

Lift only from the jacking points in your owner manual or a factory service procedure; the wrong spot can bend the pinch weld or crack a component. Position jack stands under a solid point before any part of you goes under the car; a jack is a lifting tool, not a support. Purge air from the hydraulics if the saddle sponges or will not reach full height; the procedure is in the manual. Keep the wheels and casters clean so the jack rolls straight under load. Keep the manual with the tool, because the exact setup steps and safety limits vary from model to model.

What I would check before buying

The main limitations to weigh are: costs more than steel and saddle pad wears. None of these is a deal-breaker for the right buyer, but they matter if they describe your vehicle or the jobs you do. Read the current listing details, ratings and what comes in the box before ordering.

An alternative worth comparing

The Jack Boss 3 Ton is the one I would compare next. Its strength is dual piston racing jack, and it suits fast lifting. Choose it instead if that description fits you better than the Arcan 3-Ton Aluminum. Read the alternative guide

Frequently asked questions

Is the Arcan 3-Ton Aluminum right for my vehicle?

Check the rating, size and compatibility notes against your exact vehicle and the jobs you plan before ordering. A 3-ton jack covers most cars, crossovers and light trucks; check the rating against your vehicle’s weight per corner.

Is a 2-ton jack enough for my car?

Usually for small cars, since you lift one corner at a time, but a 3-ton jack gives headroom for heavier crossovers and trucks and is the common home-garage choice.

Can I work under a car held only by a jack?

Never. Hydraulic seals can fail or bleed down. Always set the car on rated jack stands before going underneath.

Steel or aluminum?

Aluminum jacks are much easier to move and carry but cost more. Steel jacks are heavier and cheaper and fine if the jack lives in one spot.

My buying recommendation

Choose the Arcan 3-Ton Aluminum if you are among most home mechanics and its limits do not get in your way. The right floor jack pays for itself the first time it turns a shop visit into a job you finish at home.

Check the current Amazon listing

As an Amazon Associate I earn from qualifying purchases.

Compare all floor jacks