OBD2 Readiness Monitors: Pass an Emissions Test
By Roger Holden. General guidance.
Readiness monitors are self-tests your car runs on its own emissions systems. After codes are cleared or the battery is disconnected, they reset to 'not ready' and must re-run during normal driving. Many inspection programs reject a car with too many incomplete monitors, even if the check engine light is off. Check readiness with a scanner before your inspection, and drive normally for several days after a repair rather than clearing codes right before the test.
What readiness monitors check
Each monitor tests one emissions system under specific conditions — a certain temperature, speed, fuel level or idle time. When the test runs and passes, the monitor shows 'ready' or 'complete'. A monitor that has not had the right conditions yet shows 'not ready' or 'incomplete'. 'Not ready' is not a fault; it means the car has not finished checking.
| Monitor | What it checks | Often slow to complete? |
|---|---|---|
| Misfire | Cylinder misfires | No — runs continuously |
| Fuel system | Fuel trim control | No — runs continuously |
| Comprehensive components | Sensor circuits | No — runs continuously |
| Catalyst | Catalytic converter efficiency | Sometimes — needs steady cruising |
| Oxygen sensor / heater | Oxygen sensor response and heaters | Sometimes |
| EVAP | Fuel vapor leaks | Often — can need a cold start and specific fuel level |
| EGR / VVT | Exhaust gas recirculation or valve timing | Sometimes |
How many incomplete monitors are allowed
Rules are set by each state program, not by the scanner. Under the long-standing EPA guidance that many programs follow, 1996–2000 cars may typically have up to two incomplete monitors and 2001-and-newer cars one, often the EVAP monitor. Your state can be stricter or different, so check the program's own website before the test. Diesel and hybrid vehicles may follow separate rules.
Practical example: a 2015 sedan has its battery replaced the day before inspection. All non-continuous monitors reset to incomplete, and the car is turned away even though nothing is wrong. A week of normal mixed driving would usually have avoided the return trip.
How to get monitors ready again
There is no universal drive cycle that works on every car; carmakers define their own, and some publish them in service information. Normal driving over a few days — including a cold start, some steady highway cruising and some idling — completes most monitors. EVAP monitors are often the last, because they may need the tank between roughly a quarter and three-quarters full and an overnight cold soak.
- Fix the underlying fault first; monitors may not complete while a related code is present.
- Do not clear codes or disconnect the battery after the repair.
- Drive normally for several days, including a cold start, steady cruising and some idling.
- Keep the fuel tank between about a quarter and three-quarters full.
- Check readiness with your scanner before booking the inspection.
Reading readiness with a scanner
Almost every OBD2 reader, including the simplest, shows readiness status on an I/M or readiness screen, because it is a standard function. Many show a simple green, amber or red indicator for inspection readiness. Note whether the check engine light is commanded on, any pending codes and each monitor's status. If one monitor never completes after a week or more of varied driving, that is itself a diagnostic clue worth showing a technician.
Keep investigating
- Check engine light assistant
- Check Engine Light Flashing: What to Do
- Check Engine Light On but Car Runs Fine: Next Checks
- Can a Loose Gas Cap Cause a Check Engine Light?
- Dashboard Warning Lights: What Each Color Means
- Car Won't Start? A Step-by-Step Troubleshooter
- Car Battery Keeps Dying? Find the Cause
- Engine Overheating: What to Do and What It Means
- Rough Idle: Common Causes and How to Narrow Them Down
- Compare OBD2 readers
- Reading diagnostic codes